[MDPotter]

And for TA, some details on the seats. When I picked up the seats, I took both sides of the connector off the Escalade so I could have a plug and play setup. These seats are power with memory and heat, but I think I can only use the power function because a BCM is required for the heat and memory. No big deal though since I was planning on manual seats initially. I hooked up the big orange and black to a battery and confirmed that all of the movement functions work and to help in test fitting. I saw in sprint's build that he lined up the mounting holes with the front rib of the floor and I did the same thing and it's good reference point. From there, I centered the driver seat on the steering column and there is plenty of room for adjustment and a great amount of legroom. I haven't decided what I want to do for a console yet. We put the same vintage seats in my dad's 64 with a 08-13 center folding console (since they're much less creaky than the 99-06 folding consoles) but I'm not sure that I have enough width between the seats for it. I may end up building something anyway because I need to mount by bulky Gen 3 PCM and TAC module down there. I had the passenger seat all the way to the edge of the rib and I might be an inch or two short of being able to install a 08-13 console.

I forgot to take a picture with them in place.