[72cs20]

Time for an update!

More little things and some bigger things getting done. Worked on the tranny cover some more to get it to fit the floor properly. It needed most bolt holes dremeled out a little bit at the 11 o'clock position and the front upper edge ground back slightly. I got this cover from LMC and overall it's a well made piece.

Next was the floor covering. I laid down a heat/sound layer and then a vinyl floor cover. That vinyl covering is a pain in the neck to install but came out not half bad. If I had to do it again I would go with rubber or carpet. I still need to adjust the area around the t-case shifter so it fits around that tranny cover extension a little better.
With the vinyl covering in I got the shifters and boots installed. Still need to order the main transmission shifter boot.