Thread: Rear Bumper Bolt Pattern Thread
View Single Post
Old 03-12-2019, 01:18 AM   #12
71CHEVYSHORTBED402
Senior Member
 
71CHEVYSHORTBED402's Avatar
 
Join Date: Feb 2009
Location: Northern Nevada
Posts: 7,120
Re: Rear Bumper Bolt Pattern Thread
Quote:
Originally Posted by randy500 View Post
Tony I will measure my trucks tomorrow and post up.
Where is your bumper rear hole in relation to the red mount hole.
Check out this thread dude. I think zbm100's truck is the same, SWB, 2x4 with leafs. http://67-72chevytrucks.com/vboard/s....php?p=6742315

Do you mean if I use the existing front holes? It's going to be 3/10" off, guarantee it. You basically have to weld up the existing rear holes in both the inner and outer brackets, punch new ones. You could almost get away with a slot in the outer bracket, but not really because you have to cut the front off the bracket to clear what's shown post 3.
__________________
Tony
71 Custom Deluxe, SWB, 2WD, 402, A/C. I developed an assm. guide "kit" for restoring it from ground up. With assys, the guide accts for 1000s of OEM identifications and part numbers, all written in short order. 700+ images include assm, illust., charts, and points of interest. Much of the info. applies to all 67-72 GM trucks, and to a lessor degree all 67-72 GM vehicles. My build thread, and more on the guide https://67-72chevytrucks.com/vboard/...d.php?t=730025
Last edited by 71CHEVYSHORTBED402; 03-12-2019 at 01:40 AM.
71CHEVYSHORTBED402 is offline   Reply With Quote