The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Project 67 DRGNWGN

*Puropedo* · 11-29-2009, 08:40 PM

The upper control arm only goes so far up binding the balljoint preventing it going further up. I hope this makes sense, if not, try pulling the spring out, bolt the spindle back and use a jack to lift the whole assembly, you will notice the travel will stop before the LCA hits the crossmember, that is the point where the upper balljoint is binding not allowing for more travel.

11-29-2009, 08:40 PM	#64
Puropedo Account Suspended Join Date: Nov 2008 Location: Prunedale California Posts: 782	Re: Project 67 DRGNWGN - 67 Burban!! The upper control arm only goes so far up binding the balljoint preventing it going further up. I hope this makes sense, if not, try pulling the spring out, bolt the spindle back and use a jack to lift the whole assembly, you will notice the travel will stop before the LCA hits the crossmember, that is the point where the upper balljoint is binding not allowing for more travel.