View Single Post
Old 05-18-2012, 06:46 PM   #1
nds1968
Registered User
 
nds1968's Avatar
 
Join Date: Mar 2006
Location: Pittsburgh
Posts: 1,694
Exclamation Another Classic Performance Products complaint (CPP)

About 8-10 weeks ago maybe even more I ordered a set of modular spindles from Porterbuilt. They were dropped shipped from Cpp to my house.

The spindles appear to have been used for mock up. The one spindle has rust on it and the other one had grease all over it like a rotor has been installed. I wiped the grease off but it is still in the key way and where the cotter pin goes. There are also some marks maybe from a hammer or maybe all the new spindles have the marks.

Now the spindles are still perfectly usable but I expected new, unmolested spindles when I purchased them. I was a little ticked when I seen this but I never mentioned it to Porterbuilt or Cpp until a few days ago. I was cleaning my garage and I started to get ticked again so I PM'd CPPJEFF to let him aware of what they shipped me.
Attached Images
    
__________________
Nate

1967 short fleet Project Blue Goose
'If it don't bounce back... heeheehee you go hungry!" Blues Brothers

Last edited by N2TRUX; 03-18-2013 at 10:17 AM.
nds1968 is offline   Reply With Quote