The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 1965 c-10

Mnwood · 11-24-2018, 11:51 AM

Yeah you are definitely right on that one, I'm sure its an ackerman effect problem.
I was hoping to find out what knuckles/spindles I have to make sure the old tie rods etc. would work. if not I would replace them and then have it aligned.
I think I will double check the taper in the knuckle arms just to make sure of the fit with the outer tie rods and if ok its off to the alignment shop.
I want to convert to power steering but for now I would like to be able to drive it. Also its close to winter here in the Land of 10,000 bad drivers and not much time left this season.
Thanks Greg aka Mongo )

11-24-2018, 11:51 AM	#5
Mnwood Registered User Join Date: Feb 2017 Location: Minneapolis Minnesota Posts: 3	Re: 1965 c-10 Yeah you are definitely right on that one, I'm sure its an ackerman effect problem. I was hoping to find out what knuckles/spindles I have to make sure the old tie rods etc. would work. if not I would replace them and then have it aligned. I think I will double check the taper in the knuckle arms just to make sure of the fit with the outer tie rods and if ok its off to the alignment shop. I want to convert to power steering but for now I would like to be able to drive it. Also its close to winter here in the Land of 10,000 bad drivers and not much time left this season. Thanks Greg aka Mongo )