Quote:
Originally Posted by litew8
Thank you for the reply. I no longer need the door seals, so a kit isn't going to work.
I have a "Custom Deluxe", here's what I'm looking at now:
8 Piece Door Window Seal Kit For Custom & CST Trucks 280037
Includes inner felts with Chrome Bead, outer rubber seal, Division Bar Felt,&Door Glass Channel Run For Both Doors Used On CST & Custom Pickup, Suburban & Panel. LIFETIME WARRANTY.
$69.95
67-72 Division Bar Felt 360342
1967-72 Door division bar felt runs down back side of vent window bar from top at door upper frame to bottom inside door. For truck, Blazer, Jimmy, Suburban, Panel.
$12.00
67-72 Glass Run Channel 360346
1967-72 Door glass run channel, extends from inside door bottom at back of window up the rear glass run area and across top of door upper frame and ends at division bar. For Truck, Suburban & Panel.
$10.95
- Questions -
1) Are all rubber products manufactured by Precision?
2) For the 8 piece above (280037), it says "outer rubber seal", but the 4 piece anti-rattle kit (371090) says "2-outer rubber seals with chrome top bead" is included. Is there a difference for Custom Deluxe models, and why wouldn't the 8 piece kit contain outer rubber seals with "chrome top bead"?
4 Piece Custom & CST Door Window Anti-Rattle Kit 371090
For 1967-72 Truck, Blazer, Jimmy, Suburban&Panel. Includes 2-inner felts with chrome top bead, 2-outer rubber seals with chrome top bead, at bottom of window inside and out, does both doors. LIFETIME WARRANTY.
$39.95
Thanks
|
All the rubber is supplied by Precision in this kit. The part # 280037 do have a chrome top bead attached to the 2-outer rubber scrappers and the 2-inner felts in this kit. Its just not in that description and I'll see about getting it added. The division bar felts do not have chrome beads. The division bar felt was installed at GM assembly plant then they crimped a chrome bead onto the rear edge of the vent window assemblies division bar surrounding metal inside & out. When they did this they often trapped a portion of the division bar felt under the edge of this chrome bead. So when removing the division bar felt to replace it run a razor blade along the edge of the chrome bead on the felt side of it this will cut any felt trapped allowing you to remove the division bar felt liner for replacement.
The part # 280037 includes 2 division bar felts and 2 glass run channels so if you only have the 1 truck there is no need to add the part #'s 360342 division bar felt or Part# 360346 glass run channel.
we use a Part # 371090 + 2- Part # 360342 & 2 part # 360343 to make our Part # 280037 kit.
To be sure your questions get answered quickly about any of our products you can contact us direct by emailing us at
robbinspd1199@yahoo.com
as I don't always see every post here. Thanks for your interest!!
Paul @ GMCPauls