[aventur1]

jtp67-72
I would say just go slow and make sure it's tight push hard down to set as you go around that part keep the loose end pushing towards the part your pressing in the slot. The edges will seem so curl up as you go around corner so I used a very small screw driver to pull the lip up over the edge. Kinda hard to explain and the small loop wire inside the edgeing will tend to poke through, I just used the scew driver to lift edge and the wire will go back into the seal. You can use maybe stiff plastic so not to damage paint. It will be a little kinked at the 45 degree but as you shut the door it smooths out.
When you get to the end I cut it a little long then cut the bottom and used the extra rubber on top to tuck into where you began.