[gsinon]

Todays adventures had me removing the doors on the cab, then with the help of my wife and daughter we laid the cab on its back so I can work on the floor. I need to do some final welding. After that is done I will epoxy the floor and tow board area, then seam seal and spray Berliner on the bottom to help keep it nice.





With it in this position I am also going to make a cart that the cab will bolt solidly onto for when I need to move it to the shop and booth later on. The two stacked pallets have served their purpose, but nothing I trust long term.






While on its back I found a few areas I need to address first. I didn't expect this to be perfect, and in fact was pleasantly surprised that this was all their was for damage or rust.