|
Next steps - planning
At this point, on the driver side I have the following to finish up.
floor pan
outer floor
rear outer floor
rear cab brace
kick panel
rocker panel
After cutting every piece of rust in sight out, and losing my references (and making the job much more difficult), I have a new plan. I want to first build what I can see, so I've been trying to make repairs from the "outside in."
Following this, here is my planned order of operations.
1. Get the rocker panel on
2. Install the rear outer floor
3. Driver side floor pan and kick panel
4. Fully burn in the outer floor, etc.
4. Move to the passenger side.
I'm planning on doing the rear cab support last, after the cab is back together and not relying on all my bracing to hold its shape. I am going to try tip the cab forward some to make it easier. It will also make it easier to get some of the undercoating off.
Does the order of operations above seem appropriate? I appreciate any advice any of you may have. Thanks!!!
|