The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

S-31 · 04-26-2010, 10:03 PM

Thanks for all the info guys, the caster and camber part is what i've had a hard time trying to figure out. Ive set the toe on tons of straight axles (school buses) but haven't ever had to deal with the caster/camber on anything with ifs. When i replace the upper control arm bushings do you think it would be a good starting point to put the alignment shims that are currently on the control arm back in the same place they were? Or start from scratch? Thanks

04-26-2010, 10:03 PM	#5
S-31 Registered User Join Date: Mar 2010 Location: Fayetteville NC Posts: 98	Re: DIY Front End Alignment Thanks for all the info guys, the caster and camber part is what i've had a hard time trying to figure out. Ive set the toe on tons of straight axles (school buses) but haven't ever had to deal with the caster/camber on anything with ifs. When i replace the upper control arm bushings do you think it would be a good starting point to put the alignment shims that are currently on the control arm back in the same place they were? Or start from scratch? Thanks Last edited by S-31; 04-26-2010 at 10:07 PM.