|
Re: Lower Ball Joint Issue
Quote:
Originally Posted by lkt1954
Yes both nuts hang up in the same spot on this stud, but do not hang up on the other lower ball joint stud.
|
I would contact your parts source & discuss the situation before moving forward. See how they think you should proceed. Most likely, if you tighten the current one w/o them understanding the issue before then & the threads are jacked after, it becomes your problem.
Since you ran a die down it already, if you're concerned about the threads still galling I'd say your best option is to source another lower BJ & return the one that has this issue.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
|