Quote:
Originally Posted by Dieselwrencher
Nice find on the D80. You should like that a lot better. The 3:54s just work so well behind a 12v. If you decide to sell the HO rear axle I might be interested in it.
|
I have been looking for a rear axle for a while now. I really wanted a dana s 110 but the gearing is just to short, I would have had to go with 4:30 gears. But I'm happy with the dana 80 and is should be great on the interstate. I am selling it, But I cannot imagine what shipping would cost.
I removed the coil spring perches that were booger welded on.
20210925_150118 by
jarrod vanwinkle, on Flickr
Fall weather is finally here!
20210925_165858 by
jarrod vanwinkle, on Flickr
20210925_172618 by
jarrod vanwinkle, on Flickr
I also reinstalled parking brake pedal as i'm finally going to have a parking brake, well if fedex every decides to drop off my packages. I was going to make an electric parking brake as the fuse box I made is in the way but I think it will just fit with 3/8 on both sides.
20210925_204051 by
jarrod vanwinkle, on Flickr
I also had to move the manual fuel shut off on the other side. I think I will like it better here.
20210925_204057 by
jarrod vanwinkle, on Flickr
I cut off the old spring perches
.
20210926_140228 by
jarrod vanwinkle, on Flickr
I made some shock mount brackets the inside factory mount was the same place as the outside mount on the old axle. so I just had to add one tab to each side and that way II Will hopefully be able to use the dana 80 sway bar.
20210928_183640 by
jarrod vanwinkle, on Flickr
20210929_203738 by
jarrod vanwinkle, on Flickr
20210929_215026 by
jarrod vanwinkle, on Flickr
20210929_215048 by
jarrod vanwinkle, on Flickr
Imade a spring perch location jig to help locate the nre perches on to the new axle.
20210930_151119 by
jarrod vanwinkle, on Flickr
I also made a mark where the center of the old perches were before i cut them off.
20210930_151206 by
jarrod vanwinkle, on Flickr
20210930_152739 by
jarrod vanwinkle, on Flickr
20210930_152440 by
jarrod vanwinkle, on Flickr
I got lucky they ended up being 7 and 5/8 from the brake flange on each side with the jig.
20210930_152525 by
jarrod vanwinkle, on Flickr
20210930_153828 by
jarrod vanwinkle, on Flickr
20210930_153835 by
jarrod vanwinkle, on Flickr
20210930_153847 by
jarrod vanwinkle, on Flickr
20210930_153906 by
jarrod vanwinkle, on Flickr
My new overload spacers I could not find a set so i'm make my own
20210930_155258 by
jarrod vanwinkle, on Flickr
20210930_193404 by
jarrod vanwinkle, on Flickr
Wire wheeled and painted
20211001_155825 by
jarrod vanwinkle, on Flickr
20211001_155846 by
jarrod vanwinkle, on Flickr
20211001_210613 by
jarrod vanwinkle, on Flickr