I picked up a running 94 corvette to harvest as much as I can out of it. Suspension, brakes, drive train, wiring, seats, pedals etc.
It has an LT1 383 stroker and ZF 6 Speed transmission with a dana 44 rear end.
Everything seems tight but I'll open it all up later to be sure. Also going to go with a set of 4.10 gears since the ratios are so tall on the ZF trans.
Pics
Up on the lift to pull the trans
Pushed it next door to pull the motor and start deconstructing the chassis.
Getting the pedals and wiring. Only a found a couple of mice in there...
Stripping it down to the frame so we can get measurements for the new setup. The sawzaw sure makes a mess out of that dry rotted fiberglass.
Mission Accomplished.
Next step, Start striping down the truck.