Ok, well I have been busy working on replacement of the rear cab bushings. I was able to get the driver’s side replaced fairly easy. The pass side…….. uuuhhmmm not sooo much
! I ended up having to cut the bolt using my Sawzall. I kinda feel silly after the fact….
, I cut a square hole (did this to give me more room to work in – opposed to the hole saw) I learned afterwards that I probably could have used my torch to heat up the bolt at the square nut & I think it would have came loose. In any case I was finally able to get the pass. Side replaced. I painted the cab support across the mount area and I also cleaned and scuffed the frame around the area to por-15 it too
. I did take a picture after all was complete & ready for the next procedure…