Re: My 1970 GMC “Project Splice”
I had a chance to get out in the shop today and make the last two tabs for the seat bracket. I would have probably had enough time to get it all tack welded together had I not run into a stripped out nut in the floor. I decided the best remedy to this problem was to drill out the 4 mounting points and up the size of the bolt from 5/16 to 3/8. I will end up doing the same thing with the drivers side bracket so that the bolts will all be the same. I ended up being able to use one of the front mounting nuts already in the cross member on the passenger side so I will only have to weld in one nut. I would like it to resemble the factory as mush as possible from below so I will try to get a square nut in there.
|