Re: 68 Stepside Shorty - Canadian Build GMC 910
i have been avoiding welding in the rocker for fear of it not lining up properly. Today I decided to go for it to today. It all went in well welding wise. I reinstalled the door and it was well just ok. I am not 100% happy with how it all turned out but it is good enough for the scope of the project that I have planned. The door closes and the gaps are ok. The biggest issue is that the the floor is too high. It is hard to explain but I think that the door seal and the floor trim should hide it. When I cut the inner rocker away from the floor the floor sprung up and I didn't correct that before I welded in the new piece.
Will start on diver side tomorrow.
|