[Dads79GMC]

I'm still messaging the out rocker panel, it's getting close. I'll need to do some slicing and dicing, and will have to fill in pieces to get the look that is required. You can see in picture #2 that the front of the rocker panel (at the door/fender intersection, the gap in the rocker is terrible. it seems the tooling of these is getting worse!!!

Pictures:
1. Fender, door, rocker intersection (needs work)
2. Closer look at fender, door and rocker intersection
2. The mess. I need to clean the dump tomorrow!!!!!

That's it for today. Should get some quality time in the garage tomorrow. Would like to get the outer rocker and corner finally installed and the get a start on the right side. I'm hoping to get the front clip on this week in order to get a good feel for the fit of all the new panels. Need to also shorten the frame and throw on the bed as well. Keeping the fingers crossed.

Thanks Mike