[nikwho]

Hey all,
Got a new set of Dart Pro 1 aluminum heads. I'm pretty stoked for the swap, but I am trying to figure out what head gaskets to use. From my recollection, I need a pre-flattened copper wire gasket, but there's about 5,000 different options! I'd like to find one close to my 4.040" bore, where-as a lot of them are up in the 4.200" range! Trying not to give up any extra compression.

Thoughts? I seem to remember wanting a Fel-Pro gasket set ending in a 4. Just cannot remember the part number that I've ordered in the past.

Thanks,
Nik