Quote:
Originally Posted by Accelo
Bumper also has to come off. Mark the Special screws for the hood latch. They are 12 point not hex like the rest. Should be returned to the same place.
There are 4 bolts on each side bracket where it attaches to the fender. They take a 1/2 socket.
Then two on top and two on the bottom of the center support. The lower one is smaller than the others.
Then a couple on the hood latch. Depending on how you take this apart, still attached to the center support or not.
Accessing the fender bolts is the most difficult. I would try a extension with a ball socket style wobble.
|
Thanks for the insight.
I have to take my bumpers off anyway, so I can sand down and repaint them.
Good tip on marking the bolts, to make sure they get back to the right spot.
What I do on a complex project like this is to put the bolts on a piece of cardboard with pictures, just because I can’t remember everything, and just putting them in “Labeled bags” doesn’t always work.