|
Re: 1971 Stepside LS Build
Quote:
|
Also, I'm AD USAF and have almost 17 years in, thanks for your service.
|
I did 7.5 years. Wish I had stayed.
Thanks. I'm enjoying mechanical work over sanding!
Quote:
|
Looking fantastic. You would post up about new brakes and drums right after I just purchased and installed all new on my truck! I'd have taken that stuff off your hands for sure.
|
Dang! I hate I didn't post earlier. I hope someone puts them to good use. I will post them FS once I have the front calipers swapped out.
Quote:
|
I think the pinion yoke isn't centered on the axle, I noticed the same thing on mine.
|
I did some reading and this appears to be a normal set up. We shall see.
__________________
1971 C10 Stepside. LSx 6.0 with BTR Stage IV, Speed Engineering Headers, 4L80e transmission w/3200 Circle-D Stall. 3.73. Posi. Purchased this truck when I was 17. I started the rebuild (or take apart) in 1993. I have drug it around all over the country in pieces. Finally back on the road in 2021.
"I can't complain, but sometimes I still do. Life's been good to me so far."
|