Quote:
Originally Posted by Oldtruckwelder
Bam
Your truck is coming along awesome..
I like the wider board look for sure.
I was messing around with some pine to see if I could do all the router work. Went with the stock dimensions and number of boards, found out that the Boyd's tank nozzle hits dead center of two boards. I would rather do like you did by putting wide board dead center.. what width did you go with to make your boards the same?
Thanks
JT from SC
Attachment 2064048
|
Thanks for the comment on the truck and to answer your question. Your must first remember that my truck has a fleetside that is much wider than a step side bed. I used 9 1/4 on an inch planks. You are correct I centered the middle board and worked my way out on each side. Oh another tip I used one of those rabbet bits with a bearing. That way you do not have to make a jig the bearing just rides along on the bottom of the outside edge of the wood being kit. I nailed a piece of pine the same thickness of the bed wood only to just keep the router balanced from side to side.