The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**69Tom** · 01-05-2022, 02:05 PM

At present, I can tell you be very careful with the valve plunger/stopper screws. They are very small and break easily. I broke mine over torqueing it. I had to locate a whole new unit just for that part. I have been told you can JB weld it, but I don't really like JB weld.

Other than that, seems to be going ok. I guess the next check will be to see if the gasket maker actually works. Not like you can find original gaskets for these things.

01-05-2022, 02:05 PM	#3
69Tom Senior Member Join Date: Jul 2015 Location: Phoenix, AZ Posts: 1,333	Re: rebuilding 74 fuel selectors valves At present, I can tell you be very careful with the valve plunger/stopper screws. They are very small and break easily. I broke mine over torqueing it. I had to locate a whole new unit just for that part. I have been told you can JB weld it, but I don't really like JB weld. Other than that, seems to be going ok. I guess the next check will be to see if the gasket maker actually works. Not like you can find original gaskets for these things.