The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**71CHEVYSHORTBED402** · 06-19-2021, 12:46 PM

Page seven this thread shows where to drill, and where not to as well

The measurements are good but consider it a guide for a dry run. The lower sides are real easy, the moldings position 4/10" below the body line. Side moldings take a hole on each end with 3M tape clips in-between, though the upper fender moldings take a hole for each clip.

Depends on the clips you get too.

http://67-72chevytrucks.com/vboard/s...=730025&page=7

06-19-2021, 12:46 PM	#9
71CHEVYSHORTBED402 Senior Member Join Date: Feb 2009 Location: Northern Nevada Posts: 7,126	Re: Where to buy quality trim? Install? Page seven this thread shows where to drill, and where not to as well The measurements are good but consider it a guide for a dry run. The lower sides are real easy, the moldings position 4/10" below the body line. Side moldings take a hole on each end with 3M tape clips in-between, though the upper fender moldings take a hole for each clip. Depends on the clips you get too. http://67-72chevytrucks.com/vboard/s...=730025&page=7 __________________ Tony 71 Custom Deluxe, SWB, 2WD, 402, A/C. I developed an assm. guide "kit" for restoring it from ground up. With assys, the guide accts for 1000s details such as OEM identifications& part numbers, written in short order. 700+ images include assm, illust., charts, and points of interest. Much of the info. applies to all 67-72 GM trucks, and to a lessor degree all 67-72 GM vehicles. My build thread, and more on the guide https://67-72chevytrucks.com/vboard/...d.php?t=730025 Last edited by 71CHEVYSHORTBED402; 06-19-2021 at 01:17 PM.