[IronCanine]

Hopefully setting the cab in the next couple of days...in the meantime, some progress posts aren't exciting or interesting but emphasize the point that it takes a lot of time and sometimes tedious effort to get these trucks done.

The repro core support fits but is obviously different from the OE version in many ways (for instance the upper member creases and the capture nuts). Our original core support like most, was worse for wear on the bottom. We wanted to save the good original bits. So I drilled out the 80 or so spot welds on the OE core support to remove the rusty bottom and vertical supports as a unit and then ground the spot welds away from the repro one to dissect out that same structure. Then Eric spotted it all back together.