The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

jwilson645 · 11-07-2023, 02:40 PM

Been working instead of posting. Front drop axle is now in place and mocking up the front discs. Lots of parts have been rolling in.

I gotta source a small piece of 3/8" plate to cut the brackets from. I have plenty of 1/4" in the shop but never use 3/8" so I don't need a whole sheet.

I'm using 6 lug 12" rotors and the only brackets I can find online say they're for the smaller 11" rotor. I have the bracket mocked up in 1/8" steel now.

11-07-2023, 02:40 PM	#23
jwilson645 Registered User Join Date: Dec 2011 Location: Morris, Alabama Posts: 178	Re: Pawpaw's 55 GMC.......my new project Been working instead of posting. Front drop axle is now in place and mocking up the front discs. Lots of parts have been rolling in. I gotta source a small piece of 3/8" plate to cut the brackets from. I have plenty of 1/4" in the shop but never use 3/8" so I don't need a whole sheet. I'm using 6 lug 12" rotors and the only brackets I can find online say they're for the smaller 11" rotor. I have the bracket mocked up in 1/8" steel now. Attached Images Last edited by Rickysnickers; 11-07-2023 at 03:28 PM.