The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Redneck Rydes · 08-01-2020, 08:08 AM

I had the same experience with Western Chassis,I waited and waited,finally after 3 months got the spindles,and went to put the backing plates on one of them,there were NO threads,had to tap them out,no biggie,but quality control is not what it was,I have purchased a set of DJM spindles for my other truck,but haven't insatalled them yet,I am in Covid jail,truck is in S.C. and I am up here in Canada,can't get to the States to get it.

08-01-2020, 08:08 AM	#7
Redneck Rydes Registered User Join Date: Feb 2016 Location: Trenton,Ontario & South Carolina Posts: 755	Re: Little PO'D right now. I had the same experience with Western Chassis,I waited and waited,finally after 3 months got the spindles,and went to put the backing plates on one of them,there were NO threads,had to tap them out,no biggie,but quality control is not what it was,I have purchased a set of DJM spindles for my other truck,but haven't insatalled them yet,I am in Covid jail,truck is in S.C. and I am up here in Canada,can't get to the States to get it.