The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Has anybody seen this type of locking hubs?

76/85 Truck · 12-31-2011, 06:48 PM

Hello everyone! I was at the wreckingyard by my house and I found a set of these hubs... They are 19 spline and will fit my Dana 44. They are the external type. They are 1/4 turn, and they can engage/disengage either clockwise or counterclockwise. The direction you turn them does not matter, they work either way. Thanks in advance for any replies! I want to put these on my truck, but before I do I want to know if there is anybody that sells replacement parts for them, or if I should just rebuild my Mile Marker hubs and put new wave springs in them

Thanks!!!

12-31-2011, 06:48 PM	#1
76/85 Truck Registered User Join Date: Jun 2010 Location: Libby, MT Posts: 163	Has anybody seen this type of locking hubs? Hello everyone! I was at the wreckingyard by my house and I found a set of these hubs... They are 19 spline and will fit my Dana 44. They are the external type. They are 1/4 turn, and they can engage/disengage either clockwise or counterclockwise. The direction you turn them does not matter, they work either way. Thanks in advance for any replies! I want to put these on my truck, but before I do I want to know if there is anybody that sells replacement parts for them, or if I should just rebuild my Mile Marker hubs and put new wave springs in them Thanks!!! __________________ Rich My first truck!! 1976 Chevy 3/4 ton Camper Special and a 1985 GMC body. Has a 350, 4 BBL Edelbrock, with a Turbo 350, and NP205 T-case. Last edited by 76/85 Truck; 12-31-2011 at 06:56 PM.