Thread: 41-46 S10 swap
View Single Post
Old 07-04-2022, 12:51 AM   #10
joedoh
Senior Member
 
joedoh's Avatar
 
Join Date: May 2007
Location: Doodah Kansas
Posts: 7,746
Re: 41-46 S10 swap

more good alignment




front clip support rods to core support drilled and tapped. you can see that both the one ton core support and the 1/2 ton support rods both show remnants of farmer brazing.



I had to weld this rectangle tube to the core support and use leverage to get it lined up.



good alignment here too!



have to weld the front bumper mounts on in the morning, big gauge shows empty but the little gauge still shows gas, think I have enough to finish?




delivery is thursday, then I will write up instructions. impressive 50% kit reuse, that will save some money!
Attached Images
     
__________________
the mass of men live lives of quiet desperation


if there is a problem, I can have it.

new project WAYNE http://67-72chevytrucks.com/vboard/s...d.php?t=844393
joedoh is offline   Reply With Quote