|
Re: Leaking master cylinder cap.
I have a similar master. I went a couple years of driving before checking the fluid again. When I did that, a little bit of crustiness had built up on the seal. When I put the cap back on, I noticed that it started leaking. Took it off again, cleaned the crustiness off the rubber on both sides, then took a razor blade to the sealing side on the master to make sure it was clean and flat. I haven't had a leak since doing that
__________________
Christian Carpenter
1963 C10 - Frankentruck 283, 3 speed with overdrive Overdrive wiring here 1963-ish truck bed trailer - Half-Wit
1981 C10 - Penny 305, th350
1995 Dodge Dakota Sport
"I'll put it simple: if you're going hard enough left, you'll find yourself turning right." - Doc Hudson
|