The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

chiggins · 02-27-2020, 01:20 AM

I'll definitely have the block checked out by a machine shop and consult with them about anything that should be handled by them.

The rockers I picked out were COMP magnum roller tip rockers that are self aligning. If I'm able to open up my budget a little I'm sure it would be better to go full rocker.

I do recall reading about guys having vapor lock issues with the edelbrocks due to the bowls getting hot. Thats just a bridge Ill have to cross if I come to it. I have the intake that I do because it popped up on FB marketplace for cheap.

Does the rest of the build at least sound like solid power potential? Im hoping to get as close to 400 as I can.

02-27-2020, 01:20 AM	#3
chiggins Registered User Join Date: May 2015 Location: Lincolnton, North Carolina Posts: 22	Re: Vortec 350 Build, am I doing it right? I'll definitely have the block checked out by a machine shop and consult with them about anything that should be handled by them. The rockers I picked out were COMP magnum roller tip rockers that are self aligning. If I'm able to open up my budget a little I'm sure it would be better to go full rocker. I do recall reading about guys having vapor lock issues with the edelbrocks due to the bowls getting hot. Thats just a bridge Ill have to cross if I come to it. I have the intake that I do because it popped up on FB marketplace for cheap. Does the rest of the build at least sound like solid power potential? Im hoping to get as close to 400 as I can.