[diesel burner]

I knew when I bought this K20 that I wanted to do a Cummins swap and started reading up on what it would take. There were quite a few threads on here that inspired me and I read every word of them and studied the pictures religiously. I started looking for a donor vehicle and then life happened and I was set back a few years on finding a Cummins. In the mean time the 350 started burning oil badly so I pulled it and the transmission/transfer case out and put in a 383/nv4500/np241 setup. I also pulled off the service box and built a flatbed for it. I could have found a bed for it but a flatbed fits my needs better and I don't have to worry about the paint matching.
During this time frame I also managed to find a Dodge Dana 60 from a first gen. I built a new front crossmember with spring hangers and core support mounts out of 5/16 T1 steel, I did this to compensate for the wider spring perches on the dodge dana 60