The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Best cam for a stock 350 crate w/ edelbrock preformer intake and holly 600 carb

**bigmac73** · 01-21-2020, 02:37 PM

if the cam is going flat, it is best to pull the engine and strip it down. You are sending camshaft material into your bearings the more you run it and will do more damage.

I would think rebuild and possibly stroke it out, But i also understand budget as well

01-21-2020, 02:37 PM	#16
bigmac73 Senior Member Join Date: Mar 2012 Location: Chesapeake, Va Posts: 1,275	Re: Best cam for a stock 350 crate w/ edelbrock preformer intake and holly 600 carb if the cam is going flat, it is best to pull the engine and strip it down. You are sending camshaft material into your bearings the more you run it and will do more damage. I would think rebuild and possibly stroke it out, But i also understand budget as well __________________ Mike 72 C-10 Cheyenne off frame resto and Upgraded to 4 wheel disk, Tilt, Dakota Digital Dash / Rear slider. 421 SBC / TH350 3000RPM Stall Progression Ignition /Holley 750 DP/3:73 gear Eaton Limited Slip unit / 2 1/2 exhaust glasspacks