Re: Fixrupr
Here is the repair made. Clean up and wipe down, get ready to finish the paint on the bed in the morning.
For this repair I taped some mask paper around the area to be repaired so the filler primmer would not get all over everything. Then turned down the fan pattern on the gun and feathered in the filler primer in the area that was low. I had two high power halogen lamps helping with the drying times. Laid down about 4 coats over the low area with about 10 to 15 minutes between coats.
Went back in the house and watched the Boise State football game while thing cured up. Went out at Halftime and added two more dedicated breakers to my electrical panel so that I would have a dedicated for the compressor and a dedicated breaker for all the lights we are using while painting.
Here is a few shots of the repair after wet sanding with 320 and feathering with 800.
|