Re: 1967 Custom Sport Shop Truck
I have the front section of the bed fully welded! Damn that's a lot of work!
This stupid fender pissed me off. I couldn't get any of my tools in there good enough to get the dent out so I cut it out. I took it over to the bench and straightened the little booger out in a few minutes, go figure, right?
Welded it back in, gone. It will still need a bit of filler, but at least it's "flat" now.
I also got rid of the emblem holes and the giant antennae hole someone drilled in it. My body hammers and welder are getting a work out today. I will reuse the factory emblems, but I move them back towards the door and up some to line up better with the cowl lines. I like to use 3M double sided trim tape.
Pretty proud of the last pic, getting better. Pretty much zero warpage.
Last edited by 67ChevyRedneck; 02-16-2017 at 02:21 PM.
|