I have a .700" bore clutch master in stock. The threaded rod between the clevis and the rod end could be shortened. This depends on how much you are going to move the pedals. In moving the pedals, you will need to maintain the original pedal travel distance. If that is not possible, we may need to increase the bore size of the clutch master.
Quote:
Originally Posted by 62chevy302
I am using a nv3500 5 spd with internal slave cylinder. The factory master for this slave cylinder is 18mm. I would need a clutch master that matches that. Also i would like to do the lower pedal mod that i have seen many do where it lowers all the pedals. Will your linkage allow for the shorter throw of the clutch since it will be closer to the floor?
|