The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

S-31 · 04-26-2010, 07:45 PM

I was wondering if anyone here has a process they would use to align the front end of their truck themselves? My 63 is lowered in front with 3" springs and one coil cut off of those, and the rear is lowered with 5" springs. Im getting ready to rebuild the front end with new ball joints, control arm bushings, idler arm, etc and there arent any alignment shops around here that i really trust to put a wrench on my truck. Im sure with all the guys on here that do all their own work that somebody has come up with a method to do this. Any ideas?

04-26-2010, 07:45 PM	#1
S-31 Registered User Join Date: Mar 2010 Location: Fayetteville NC Posts: 98	DIY Front End Alignment I was wondering if anyone here has a process they would use to align the front end of their truck themselves? My 63 is lowered in front with 3" springs and one coil cut off of those, and the rear is lowered with 5" springs. Im getting ready to rebuild the front end with new ball joints, control arm bushings, idler arm, etc and there arent any alignment shops around here that i really trust to put a wrench on my truck. Im sure with all the guys on here that do all their own work that somebody has come up with a method to do this. Any ideas?