The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**kev2809** · 01-31-2022, 08:33 AM

well, I had ordered a new sleeve just because i had it off. the new one would not go back on at all. so I installed a new o ring with the original sleeve and it went back on.

hope it doesn't leak. I will know in a few months when I try to drive it.

before I pulled the drivetrain there was a little trans fluid on the slip yoke ujoint

01-31-2022, 08:33 AM	#3
kev2809 low n' slo Join Date: Mar 2009 Location: rosenberg, texas Posts: 5,133	Re: 4l60e shaft tube install well, I had ordered a new sleeve just because i had it off. the new one would not go back on at all. so I installed a new o ring with the original sleeve and it went back on. hope it doesn't leak. I will know in a few months when I try to drive it. before I pulled the drivetrain there was a little trans fluid on the slip yoke ujoint __________________ 67 1/2 ton Suburban - Project DRGNWGN. Build thread -_--_--_ _________ _--_-_ -/____\|__\|__\__ ,.,,,.,.,,.,\|_O _______ O_]