Re: C10CJ: A Pro-touring '71 Stepside on a No Limit Pro-C10 Chassis
Got the bulk of the chassis setup complete. The rear end is all buttoned up. Got the 4-link adjusted and set pinion angle to ~2.1 degrees up. I've got the engine set at 3.5 degrees down to give me the minimal interference with the cab at full bump. Unfortunately, that means I need to notch the back of the cab and the rear cross member between the cab mounts. But, the driveline is essentially done. Aside from exhaust and plumbing (brakes/fuel), the chassis is ready to drive. Of course, there is still a good chunk of work left to do before the truck is truly drivable.
|