The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Building a Vortec 350, am I doing it right?

chiggins · 02-27-2020, 10:33 AM

Hey Vale is just a 15 minute drive from home for me!

So I'll probably ditch the main studs and put that cash towards roller rockers. I believe I did pick out 7/16 studs, there was a reasonably priced set by COMP on Summit. As for machine work, do you know of any shops in the area that aren't gonna charge an arm and a leg for decking and such? I've talked with Flowers NAPA over in Hickory but haven't quoted decking.

02-27-2020, 10:33 AM	#12
chiggins Registered User Join Date: May 2015 Location: Lincolnton, North Carolina Posts: 22	Re: Building a Vortec 350, am I doing it right? Hey Vale is just a 15 minute drive from home for me! So I'll probably ditch the main studs and put that cash towards roller rockers. I believe I did pick out 7/16 studs, there was a reasonably priced set by COMP on Summit. As for machine work, do you know of any shops in the area that aren't gonna charge an arm and a leg for decking and such? I've talked with Flowers NAPA over in Hickory but haven't quoted decking.