Re: Project: Montezuma
small progress..
Adjusted the gap between the rocker and corner to match door line. Will fill with seam sealer later but it will still be noticeable and wanted it to look good.
Had to do a lot of splicing on the rear side of the rocker to match the rear pillar.
Also had to split the rocker all the way down and push it in to match the door edge (which I now filled that gap in).
I cut the end cap out of the front side of the rocker and remade a new cap so the rocker would fit right up in the position I wanted it (when taking it on/off). I plan to weld all around that seam to hopefully prevent water/dirt getting thrown up in that area from the tires. Put weld thru primer on it before tacking it in.
|