Re: Dana 60 Problems
Here are my measurements with the truck sitting in the garage. All measurements are based on angled down from front to rear of truck I'm also including the rear axle in this definition.
Engine/trans 2.2, front drive shaft 3.3, rear drive shaft 4.3, rear end 2.6. Per Spicer's app operating angles of the u-joints are 1.1 1 and 1.7
I obtained these from shimming the trans mount up slightly, shimming center carrier support down little over 1" and 2 degree shims at the left spring perches.
I have not had a chance to measure the center line of everything horizontally yet, but eyeballing it trans looks to be centered and rear end is slightly towared the passenger side.
__________________
Terry
1970 Custom Camper/C20 , GM Crate 350/7004R, Dana 60, factory AC
|