[hpcgmc]

Hey Jason, haven't seen any posts from you in awhile, but thought I'd give you an update on the mastercoat. I applied the silver primer, mostly with a foam brush, and it came out fantastic! Temp was about 70 degrees with 30-40% humidity.

Then I applied the AG111 black topcoat and it didn't come out so well. Temp and humidity were about the same. I used a cheap foam brush and a cheap 3" brush and got lots of swirls, brushmarks and runs. I'm going to sand it down and try again this weekend, if it's a little warmer. About 2/3 through the painting, I thinned the paint out a bit and it worked a little better.

I assume alot of the problem is that I have very little experience painting. I'll try thinning it out a bit more and using a better quality brush next time. I don't have any way to spray it. If it comes out crappy a second time, I might just topcoat with a rattle can.