Re: OCHRE 72 K20 Restoration
Thanks again Pete!
So with this information, I’m not sure what I have. Stamped bumper portion is correct, front plate correct, had aluminum diamond plate riveted in in place of the steel diamond plate, but has the original holes for the steel diamond plate. Angled front plate supports are correct. The difference is this bumper has a lot more structural support than the other bumpers, and the angled outer bumper supports are different, and the brush guard. All the welds look factory except possibly the controller stand. Did they make different models, or has this one just been beefed up and added to? Hmmm
|