The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

MP&C · 02-19-2013, 11:10 PM

Back to welding... All clamped up, again...

First set of tacks...

Weld penetration, the back side....

I had someone asking about the process I used with the mig, so I took the close ups to show it a little better... Weld, planish, grind, overlap, repeat...

Planishing as you go helps to keep the panel's shape in check...

Still needs a bit of bumping but not too bad overall..

02-19-2013, 11:10 PM	#19
MP&C Registered User Join Date: Jan 2013 Location: Leonardtown, MD Posts: 1,633	Re: 55 Wagon Progress Back to welding... All clamped up, again... First set of tacks... Weld penetration, the back side.... I had someone asking about the process I used with the mig, so I took the close ups to show it a little better... Weld, planish, grind, overlap, repeat... Planishing as you go helps to keep the panel's shape in check... Still needs a bit of bumping but not too bad overall.. __________________ Robert