The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 55.2-59 Dynacorn International body replacement panels

vics stuff · 11-15-2020, 01:39 PM

dsraven , I like the looks of the big back window. Plans are to use most of the rear cab of the 55 GMC and all the trim. The reason I am not using the 55 GMC is that it looked like someone used a piece of equipment to move the truck around and almost every body panel has been damaged , except the back of the cab and the stainless body trim . These trucks reside in Nevada and both have minimal rust.
Will see when I get to the point of starting this truck. As a side note , there are some good pieces on this 55 GMC that I would sell once I am done with the conversion.
Vic

11-15-2020, 01:39 PM	#7
vics stuff Registered User Join Date: May 2011 Location: Reno Nevada Posts: 378	Re: Dynacorn International body replacement panels dsraven , I like the looks of the big back window. Plans are to use most of the rear cab of the 55 GMC and all the trim. The reason I am not using the 55 GMC is that it looked like someone used a piece of equipment to move the truck around and almost every body panel has been damaged , except the back of the cab and the stainless body trim . These trucks reside in Nevada and both have minimal rust. Will see when I get to the point of starting this truck. As a side note , there are some good pieces on this 55 GMC that I would sell once I am done with the conversion. Vic