[dwntwn]

I wanted to use what I had as much as possible—I was even going to use the first gen engine mounts if I could. I followed the builds on this site and there was one on Facebook that was informative. There was a lot of photos of second gen intercoolers.

These photos show the stock First Gen setup... I liked how everything fit together. Brutally simplistic.

The engine and driveshaft angles are from my D250 sitting on level ground before anything was taken out. I was going to keep the angles as close to this as possible when the Cummins goes into the Suburban. (Note: Driveshaft photo is upside down...don't know how to fix that)