Re: power window regulators on the cheap
someone on youtube asked for more of a write up so here it goes
step1 remove the spring carefully
step2 ground down crank rivets and remove it.
step3 ground down the two rivets thet hold the gear to the shaft and
drive them out.
step4 turn the gear down 90 degrees and weld it to the shaft.
step5 trace and cut out motor plate.
step6 cut 1 1/2 hole for motor gear to pass through and drill mounting holes (look at pattern) and test fit motor.
i would the 1/4 inch hole and one of the 7/32 to be tapped and mount
motor to mark the last hole to be drilled and tapped.
|