The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Craven93 · 01-12-2021, 05:50 PM

I'm tearing down my Muncie 3 speed out of a 1972 c10. I believe it's a 330. I'm replacing the extension bushing and all the gaskets. I'm trying to remove the reverse ideler shaft so I can move the reverse ideler gear out of the way. The manual says to drive the reverse ideler shaft and key out of case with a brass drift. However there is hardly any room inside the transmission to get a punch or hammer in there. Does anyone have experience removing this pin? Any help is appreciated...

Thanks!

01-12-2021, 05:50 PM	#1
Craven93 Registered User Join Date: Aug 2020 Location: Johnston IA Posts: 8	Muncie 3 speed pin removal? I'm tearing down my Muncie 3 speed out of a 1972 c10. I believe it's a 330. I'm replacing the extension bushing and all the gaskets. I'm trying to remove the reverse ideler shaft so I can move the reverse ideler gear out of the way. The manual says to drive the reverse ideler shaft and key out of case with a brass drift. However there is hardly any room inside the transmission to get a punch or hammer in there. Does anyone have experience removing this pin? Any help is appreciated... Thanks! Attached Images Last edited by Craven93; 01-12-2021 at 06:00 PM.