The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

FAKKY · 11-24-2016, 04:06 PM

looking at a couple videos seems like I can just leave the clutch and bellhousing attached to engine. Remove Trans and seperate and then pull each.

Wasnt sure if clutch would remain engaged to input shaft etc.

Then pull clutch off engine once pulled out.
Off to thanksgiving deal ...... do this tomorrow.

11-24-2016, 04:06 PM	#28
FAKKY Registered User Join Date: Sep 2016 Location: Redington Beach Posts: 1,312	Re: 57 Panel "FAKMLC" build looking at a couple videos seems like I can just leave the clutch and bellhousing attached to engine. Remove Trans and seperate and then pull each. Wasnt sure if clutch would remain engaged to input shaft etc. Then pull clutch off engine once pulled out. Off to thanksgiving deal ...... do this tomorrow.